The above output will most likely list multiple disks attached to your system. I/O size (minimum/optimal): 512 bytes / 512 bytesĭevice Boot Start End Sectors Size Id Type
Sector size (logical/physical): 512 bytes / 512 bytes Upon executing the above command you will get an output similar to the one below: Disk /dev/sdc: 7.4 GiB, 7948206080 bytes, 15523840 sectors
Video Example on how to mount USB in Linuxįdisk command requires administrative privileges to access the required information, thus, from this reason, the commands needs to be executed as a root user or with sudo prefix. $ – requires given linux commands to be executed as a regular non-privileged user # – requires given linux commands to be executed with root privileges either directly as a root user or by use of sudo command Privileged access to your Linux system as root or via the sudo command. Requirements, Conventions or Software Version Used How to mount USB drive in Linux Software Requirements and Conventions Used Software Requirements and Linux Command Line Conventions Category To gain more understating read the subsequent paragraphs. The video example below will illustrate the entire process of mounting USB drive on Linux system. Mounting USB drive is no different than mounting USB stick or even a regular SATA drive. If you are using desktop manager, you will most likely be able to use it to mount USB drive for you.
It was hack-y but because the device console logs in as root, I was able to update the local VMware horizon client options to include my “fix.” After validating that this worked, I have been able to escalate to the vendor to add support for this device into their firmware.The following tutorial explains how to mount USB drive in Linux system using terminal and shell command line.
UPDATE 2: I ended up getting this working temporarily on the device firmware even without the drivers being loaded. While I still have some work to do on getting this working on the endpoint it is a step in the right direction. Still need to coordinate with our endpoint vendor how to add this config to their firmware along with loading the CDC_ACM drivers to their kernel (they were removed).
So fun story, I was able to get redirection working on stock Ubuntu 18.04 desktop by adding the following to the Horizon Client config file: viewusb.AllowDevDescFailsafe = "true" Usually, i'm able to see at least a deny if my USB inclusion policies aren't set properly but it isn't even listed even after preemptively setting the right PID/VID in the configuration file.Īnyone have any thoughts on if this is a Linux issue or a VMware client issue? I have tickets open on both sides of support but right now I'm just seeing if anyone else has seen a similar issue and can point me in the right direction. but is not showing up in the USB redirection logs for the Horizon client (version: 2006) as either a recognized device and does not give any output as an allowed or denied device at all. It is showing up as a device in the local OS usb devices list, is getting power, etc. So I'm attempting to get a USB Pinpad (Ingenico Lane/3000 - basically an EMV / contactless payment compatible POS card reader) to redirect on a Ubuntu 18.04 kernel 5.0.0 based zero client.